Controls - GE ADHL50 Owner's Manual

Controls

Appearance may vary by model.
Controls
NOTE: When the bucket is full or removed, the controls cannot
be set.
1. Power Pad
Press to turn the dehumidifier on and off.
NOTE: Turning off the power by pressing the Power button
does NOT disconnect the appliance from power supply.
Controls the fan speed.
Press to select either High, Medium, Low, or Smart Dry fan
speed.
Set the fan control to High for maximum moisture removal.
When the humidity has been reduced and quiet operation is
preferred, set the fan control to Medium or Low. Smart Dry
compares the set humidity level with the actual humidity and
adjusts the fan speed automatically.
3. Display
Shows the set % humidity level while setting, then shows the
actual (+/– 5% accuracy) room % humidity level.
The humidity level can be set within a range of 35%
increments or in Nonstop mode for continuous operation. To
set the unit for continuous operation, press the
the "Nonstop" indicator light is illuminated.
NOTE: If Nonstop is selected, the dehumidifier will operate
continuously at its maximum dehumidification settings if
attached to a hose to drain or until the bucket is full. For
drier air, press the
(%). For damper air, press the
percent value (%). When you first use the dehumidifier, set
for the dehumidifier to achieve the humidity level. If you still
have damper air than desired, set the humidity level to a lower
setting or select Nonstop for maximum dehumidification.
5. Filter Timer
will glow to remind you to clean the filter. Remove the filter and
clean it.
Press and hold Filter button for 3 seconds to reset the filter
reminder. See the Care and Cleaning section.
4
pad and set to a lower percent value
pad and set to a higher
6. Delay Off
While the dehumidifier is operating press the Delay button.
Press the
want the dehumidifier to continue to operate before turning
Off.
NOTE:
showing the current humidity after 5 seconds have passed.
Pressing the Delay button will display the number of hours left
on the delay.
Delay On
While the dehumidifier is off press the Delay button.
Press the
want the dehumidifier to remain off before turning On.
NOTE: The display will show the number of hours left until the
dehumidifier turns on.
To cancel the Delay:
Press the Delay button once, the hours remaining on the Delay
will appear on the display. Press the Delay button again and the
Delay will be cancelled.
7. Pump (on some models)
to activate the internal pump for automatic removal of
pad until
condensate. The internal pump indicator light will remain
illuminated after 3 seconds. Press to deactivate the pump.
Before turning on the pump, ensure the hose is connected.
8. Empty Indicator
The "Empty" indicator will blink when the bucket is ready to be
emptied, or when the bucket is removed and/or not replaced in
the proper position.
9. WiFi Connect Pad (on some models)
Enables connection of the dehumidifier to the home WiFi.
GEAppliances.com/connect.
/ buttons to select the number of hours you
/ buttons to select the number of hours you
49-5000545 Rev. 1