Jci1: Chassis Intrusion Connector; Jlpt1: Parallel Port Connector - MSI B350 TOMAHAWK User Manual

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

JLPT1: Parallel Port Connector

This connector allows you to connect the optional parallel port with bracket.
Normal
(default)
2
1
1 RSTB# 2
4 ERR# 5
7 PRND2 8
10 Ground 11
13 PRND5 14
16 Ground 17
19 ACK# 20
22 Ground 23
25 SLCT 26
Trigger the chassis
intrusion event
26
25
AFD# 3
PRND1 6
LPT_SLIN# 9
PRND4 12
Ground 15
PRND7 18
Ground 21
PE 24
No Pin
Overview of Components
PRND0
PINIT#
PRND3
Ground
PRND6
Ground
BUSY
Ground
33