Restore Factory Settings - HomeMatic HmIP-STH Mounting Instruction And Operating Manual

1x long red
lighting
6x long red
flashing
1x orange and
1 x green
lighting (after
inserting
batteries)
8

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the temperature and
humidity sensor please proceed as follows:
To remove the sensor (B) from the frame, take
•
hold of the sides of the sensor and pull it out (see
figure 2).
Transmission
failed or duty
cycle limit is
reached
Device defec-
tive
Test display
Restore factory settings
Please try again (see
sec. „7.2 Command
not confirmed" on
page 42 or „7.3
Duty cycle" on page
43).
Please see your app
for error message or
contact your retailer.
Once the test
display has stopped,
you can continue.
45