Adhesive Strip Mounting; Screw Mounting - HomeMatic HmIP-STH Mounting Instruction And Operating Manual

Start-up
5.2.1

Adhesive strip mounting

For mounting the assembled device with adhesive strips,
please proceed as follows:
• Choose a site for installation.
Make sure that the mounting surface is smooth,
solid, non-disturbed, free of dust, grease and
solvents and not too cold to ensure long-time
adherence.
• Fix the adhesive strips (E) on the back side of
the mounting plate (D) in the provided area. You
should be able to read the letters on the back side
(F) (see figure 4).
• Remove the protective film from the adhesive
strips.
• Press the assembled temperature and humidity
sensor with the back side to the wall in the position
where it should subsequently be attached.
5.2.2

Screw mounting

For mounting the temperature and humidity sensor with
the supplied screws, please proceed as follows:
• Choose a site for installation.
36