Equalizer Control - Kenwood DNX9170DABS Instruction Manual

Fader / Balance
■
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■
[Center]
Clear the adjustment.

Equalizer Control

You can adjust equalizer by selecting the
optimized setting for each category.
1
Press the [MENU] button.
h Popup menu appears. h
2
Touch [Audio].
h Audio screen appears.
h
3
Touch [Equalizer].
4
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (dotted frame area)
■
Adjust the gain level by touching the each
frequency bar.
You can select frequency bar and adjust its
level by [R], [S].
Preset Select
■
Displays the screen to recall the preset
equalizer curve.
Memory
■
Saves the adjusted equalizer curve from
"User1" to "User4".
Initialize
■
The current EQ curve returns to flat.
ALL SRC
■
Apply the adjusted equalizer to all sources.
Touch [ALL SRC] and then touch [OK] on the
confirmation screen.
Bass EXT (Bass Extend Settings)
■
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5
Hz.
SW Level
■
Adjusts the subwoofer volume. This setting
is not available when subwoofer is set to
"None". See Speaker/ X'over setup (P.70).
Ñ
Recall the EQ curve
1
Touch [Preset Select].
2
Select EQ curve.
NOTE
• [iPod] is available only during iPod source.
Ñ
Save the EQ curve
1
Adjust the EQ curve.
2
Touch [Memory].
3
Select where to save.
Controlling Audio
73
English