Table of Contents
Advertisement
Problem
The spin phase does not
operate or the washing
cycle lasts longer than
usually.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes an
unusual noise.
The washing results are
not satisfactory.
You cannot set an op-
tion.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
14. TECHNICAL DATA
Dimension
Possible solution
Set the spin programme.
Make sure that the drain filter is not clogged. Clean the filter,
if necessary. Refer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin phase
again. This problem may be caused by balance problems.
Make sure that the couplings of the water hoses are tight
and there is not water leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct
quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure the levelling of the appliance is correct. Refer to
'Installation'.
Make sure that the packaging and/or the transit bolts are re-
moved. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
Width/ Height/ Depth/
Total depth
595 mm / 850 mm / 380 mm / 420
mm
ENGLISH
21
Advertisement
Table of Contents
