Fingerprint Reader Assembly - HP ProBook 430 G4 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly (includes bracket)
Fingerprint reader insert (part of the Plastics Kit; for use in models without a fingerprint reader)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door (see
b. Hard drive
c. Keyboard (see
d. Top cover (see
Remove the fingerprint reader assembly:
1. Position the top cover upside-down.
2. Slide the bracket toward the side of the top cover, and then lift it off the fingerprint reader board (1).
52 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service doors on page
(Hard drive on page 33)
Keyboard on page 42)
Top cover on page 49)
(Battery Safe mode on page
31).
Spare part number
905728-001
905727-001
30).