Table of Contents
Advertisement
M.2 solid-state drive
Description
256-GB, TLC
128-GB, TLC
Before removing the solid-state drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Place the computer in "Battery Safe mode"
3.
Disconnect all external devices connected to the computer.
4.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5.
Remove the service door (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×4.0 screw (1) that secures the solid-state drive to the computer. (The edge
of the module opposite the slot rises away from the computer.)
2.
Remove the solid-state drive (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
(Battery Safe mode on page
Service doors on page
31).
Spare part number
905799-001
905800-001
30).
Component replacement procedures
41
Hide quick links:
Advertisement
Table of Contents
