Speedometer - Yamaha GRIZZLY 350 YFM35GDXG Owner's Manual

EBU26933
Oil temperature warning light "
This warning light comes on when the engine
overheats. When this occurs, stop the engine as
soon as it is safe to do so, and allow it to cool.
The electrical circuit of the warning light can be
checked by turning the key to "ON", with the en-
gine stop switch set to "
4 start switch.
If the warning light does not come on while the
start switch is being pushed, or if the warning light
remains on after the start switch is released, have
a Yamaha dealer check the electrical circuit.
If the warning light stays on when the engine is
cool, have a Yamaha dealer check the electrical
circuit.
ECB00011
NOTICE
 The engine may overheat if the ATV is over-
loaded. In this case, reduce the load to spec-
ification.
 Start the engine after making sure that the
warning light is out. Continuous use while
the warning light is on may cause damage to
the engine.
"
", and then pushing the
EBU17954
On-Command four-wheel-drive indicator
light " "
This indicator light comes on when the On-Com-
mand four-wheel-drive switch is set to the "4WD"
position.
TIP
Due to the synchronizing mechanism in the differ-
ential gear case, the light may not come on until
the ATV starts moving.
EBU18024

Speedometer

This speedometer is equipped with an odometer
and a tripmeter. The tripmeter can be reset to zero
with the reset knob. Use the tripmeter to estimate
how far you can ride on a tank of fuel before going
to reserve. This information will enable you to plan
fuel stops in the future.
4-3