Charging With The Ac Adaptor; Power On / Off; Power On - Oregon Scientific MP303 User Manual

When the unit is in charging stage, the battery icon keeps changing,
increasing from one segment to two segments and then three segments
(full) continuous until it is fully charged. After the unit is fully charged,
the full battery icon is displayed.
NOTE: Charging only begins after the computer has been turned on.
When the battery is fully charged, the battery icon shows and will blink
slowly. The battery status indicators are as follows:
NOTE: When the battery icon shows, this indicates the battery is about
to run out of power within a few minutes. Recharge the battery as
soon as possible.
IMPORTANT: It is important to slide the "ON / OFF" switch on the
back of the MP3 player to "OFF" when the unit is not in use. (This
prevents the MP3 player from using all it's power).

CHARGING WITH THE AC ADAPTOR

Connect the AC power adaptor supplied with the player to the USB connector
of the player. The AC cable and plugs differ from region to region.
NOTE: The charging time is approx. 3 hours.

POWER ON / OFF

POWER ON

To turn on your MP3 player:
1. Press and hold the MENU / ON button for 2 seconds.
MP303 Eng r10 OP
Low
Medium
The Oregon Scientific "splash screen" will
appear to indicate system software is loading
from the hard disk drive. When the unit is fully
powered on (all system software loaded and
active), the unit will display the Main Menu.
7
Full
7
9/16/04, 5:47 AM