Toro 38622 Operator's Manual page 16

1.5 mm) from the front of the slot to the front edge of the
pin (Figure 37).
Figure 37
1. Pin
If the left hand (traction) cable is not properly adjusted,
do the following steps:
1. Loosen the jam nut.
2. Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3. Tighten the jam nut (Figure 38).
Figure 38
1. Jam nut
Checking and Adjusting the
Auger/Impeller Cable
Check and adjust the auger/impeller cable after the first
2 operating hours, then yearly thereafter.
1. Remove the 2 screws from the right side of the belt
cover as shown.
2. Lift up the right side of the belt cover (Figure 39).
2. Turnbuckle
Figure 39
3. With the auger/impeller lever disengaged, ensure that
the gap between the auger clutch assembly and the tab
is 1/16 inch (1.5 mm) (Figure 40).
Figure 40
1. Tab
4. If the auger/impeller cable is not properly adjusted, do
the following steps:
5. Loosen the jam nut (Figure 41).
Figure 41
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable (Figure 41).
7. Adjust the turnbuckle until you obtain the proper gap.
16
2. Turnbuckle