Toro 74833 Operator's Manual page 45

brackets, spring, and discharge deflector (Figure 64).
Remove the damaged or worn discharge deflector.
1
3
5
1. Deflector assembly
2. Deck brackets
3. Rod
2. Position the new discharge deflector assembly with
the bracket ends between the welded brackets on the
deck as shown in Figure 64.
3. Install the spring onto the straight end of the rod.
Position the spring on the rod as shown in so the
shorter spring end is coming from under the rod
before the bend and going over the rod as it returns
from the bend.
4. Lift the long end of the spring and place it into the
notch on the deflector assembly bracket (Figure 65).
4
G006036
Figure 64
4. Spring
5. Spring installed over the
rod
2
1. Rod and spring assembly
partially installed
2. Long end of the spring
installed into the notch in
the deflector bracket
5. Secure the rod and spring assembly by twisting it so
the short end of the rod can be placed behind the
front bracket welded to the deck (Figure 65).
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector
up to test that it snaps to the full down position.
45
2
1
3
G006049
4
Figure 65
3. Rod, short end, moved
behind mower bracket
4. Short end, retained by
mower bracket.