Servicing The Fuses - Toro 74255 Operator's Manual

Charging the Battery
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep
sparks and flames away from battery.
Important: Always keep the battery
fully charged (1.265 specific gravity). This
is especially important to prevent battery
damage when the temperature is below 32°F
(0°C).
1. Remove the battery from the chassis.
2. Charge battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 4-6 amps.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 45).
Figure 45
4. Install the battery in the machine and connect
the battery cables; refer to Installing the
Battery.
Note: Do not run the machine with the
battery disconnected, electrical damage may
occur.

Servicing the Fuses

The electrical system is protected by fuses. It
requires no maintenance, however, if a fuse blows
check component/circuit for malfunction or short.
Fuse: Main F1-30 amp, blade-type (Figure 46)
1. Raise the seat to gain access to fuse holder.
2. To replace fuses pull out on the fuse to remove
it (Figure 46).
Figure 46
1. Main-30 amp
Fuse: Fuel Pump 10 amp, blade-type
(Figure 47)
Fuse: Engine Fuse 20 amp, blade-type
(Figure 47)
3. Locate fuses in the left rear of machine. Pull
plastic clip out and down to gain access to
fuses in holders (Figure 47).
4. To replace fuses pull out on the fuse to remove
it (Figure 47).
Figure 47
1. Engine-20 amp
2. Fuel Pump-10 amp
40
3. Plastic clip