Drive Mounting - Seagate ST3000DM008 Product Manual

www.seagate.com

3.4 Drive mounting

Users can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-
mounting holes. Refer to
precautions when mounting the drive:
• Allow a minimum clearance of 0.030 inches (0.76mm) around the entire perimeter of the drive for cooling.
• Use only 6-32 UNC mounting screws.
• The screws should be inserted no more than 0.120 inch (3.05mm) into the bottom or side mounting holes.
• Do not overtighten the mounting screws (maximum torque: 6 inch-lb).
Figure 2 Mounting dimensions (2/3-disk: 2TB to 3TB models)
4.010 in max
101.85 mm
1.028 in max
26.11 mm
3x 0.250 ± .010 in
6.35 ± .25 mm
BOTH SIDES
Drawings are for mounting hole reference only.
Note
PCBA show in pictorial only and can vary based on specific customer configurations.
Seagate BarraCuda Product Manual, Rev. D
Figure 2 and Figure 3 for drive mounting dimensions. Follow these important mounting
5.787 in max
146.99 mm
4.00 in
101.60 mm
1.638 in
41.61 mm
2x 1.750 in
44.45 mm
Configuring and Mounting the Drive
1.013 ± .050 in
25.73 ± 1.27 mm
0.680 ± .050 in
17.27 ± 1.27 mm
TOP OF LABEL
Temperature
Check Point
5 TYP
1.122 ± .020 in
30.99 ± .51 mm
3X 6-32 UNC-2B
3 MINIMUM THREAD DEPTH
0.12 MAXIMUM FASTENER
PENETRATION BOTH SIDES
2x 1.625 ± .020 in
41.28 ± .51 mm
2x 0.125 in
3.18 mm
4X 6-32 UNC-2B
3 MINIMUM THREAD DEPTH
0.12 MAXIMUM FASTENER
PENETRATION
2x 3.750 in
95.25 mm
C L OF DRIVE
0.814 in
20.68 mm
C L OF CONNECTOR
DATUM B
0.138 in
3.51 mm
22