Advertisement
NetWare
The procedure below applies to the NPS 650 Print Server Mode only
and is recommended only if you have a small network with just a few
file servers. If you prefer to use the Remote Printer Mode or if you
have a larger network, see the NPS 650 User's Manual.
Setup and printing is done using the Novell PCONSOLE and
CAPTURE applications respectively. If you need to configure your
NPS 650 beyond the PCONSOLE capabilities, refer to the User's
Manual.
Add a Print Server:
1. Log in as Supervisor to a file server from a client work station.
2. Start PCONSOLE. Press <F4> for Bindery Mode if you are using
NetWare version 4.xx
3. Select Print Server Information (NetWare 3.xx) or Print Servers
(NetWare 4.xx).
4. Press <Insert> to add a new Print Server.
5. Type the print server name as AXIS<nnnnnn> (<nnnnnn> are
the last six digits of your NPS 650 serial number). Press <Enter>.
6. Press <Escape> to return to PCONSOLE main menu.
Repeat this procedure for each file server using the NPS NPS 650.
Link a Print Queue to the Print Server:
1. Select Print Queue Information (NetWare 3.xx) or Print Queues
(NetWare 4.xx) from the PCONSOLE main menu. If you plan
to use an existing queue, skip to step 4.
2. Press <Insert> to add a new print queue.
3. Type a queue name, and press <Enter>. If you have more than
one printer attached to the NPS 650 the printout can be directed
to LPT1, LPT2 or COM1 by appending !1, !2 or !3 to the queue
name.
4. Select the queue to be serviced by your NPS 650.
5. Select Queue Servers (NetWare 3.xx) or Print Servers (NetWare
4.xx) in the Print Queue Information menu.
6. Press <Insert> to display the Queue Server Candidates.
7. Select AXIS<nnnnnn>.
8. Press <Escape> to return to the main menu.
Restart your NPS 650 (power-off/power-on) to connect your print
queues.
Advertisement
