Table of Contents
Advertisement
Installation
Positioning the appliance in
the wall housing unit
To position the appliance correctly,
cut the spacer strip to the required
depth T, and then attach it to the
back of the appliance:
T= Wall unit depth K minus depth of
appliance G
^ Example a shows installation without
a lightshield and the front edge of the
pushed in deflector plate is aligned
with the front of the wall housing unit.
A shelf with a depth of at least 95 mm
is required.
^ Example b shows installation with a
lightshield to blend in with
surrounding kitchen furniture. The
installation position is adjusted by the
thickness b of the front panel plus
5 mm for the bracket DML 400.
The base shelf must be accordingly
deeper.
The building-in space for fitting the
rangehood must not be smaller than
180 mm.
If it is smaller than 180 mm, position the
rangehood further back and trim the
spacer strip T accordingly.
The position of the deflector plate can
be corrected later by moving it
forwards a maximum distance of
35 mm.
^ Cut the spacer strip supplied to
measurement T.
Score along the groove for the
smaller measurement as shown, and
remove the surplus.
22
^ Screw the spacer strip to the bottom
of the sides of the housing, flush with
the rear wall.
^ Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
Hide quick links:
Advertisement
Table of Contents
