AEG SCS31800S1 User Manual page 11

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1
2
1
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
Possible cause
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
1. At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the
light comes on.
3.
Solution
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower temper-
ature.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
11