Advertisement
Update to Page 45 of Use and Care Guide: LGB346 164D2764P082 79-4096
(Sealed Burner models only) or Converting Back to Natural Gas from LP
3
CONVERTING SURFACE BURNERS
Burner Cap
Burner Head
Screws
Burner Base
Orifice Spud
Gas Inlet Tube
1. Remove the grates, burner caps and
burner heads.
2. Using the Torxdriver, remove the burner
bases by unscrewing the 3 small screws in each
base. Lift the burner straight out.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing the spud from the
fitting with a 7 mm or small adjustable wrench
(depending on the size of your spuds). Apply a
3/4" wrench to the hex on the gas inlet tube
as a back-up when removing the spud to
prevent the aluminum tube from twisting.
4. Install the orifice spuds according to one of
the following diagrams (see
or natural gas, depending on which you are
converting to.
CONVERTING TO LP GAS
A
or
B
) for LP gas
A
Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed
with this Use and Care Guide. LP orifice spuds
have a 2-digit number and the letter "L" on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
Front of Range
B
Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, with the letter "N"
underneath denoting the location on the range
where it is to be installed as shown below.
II
N
II
N
Front of Range
I
N
III
N
Advertisement
