Advertisement
Proper care and cleaning are important so your range
will give you efficient and satisfactory service. Follow
these directions carefully in caring for it to help assure
safe and proper maintenance.
CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS
(IF SO EQUIPPED) IN PLACE.
Sealed Burner Assemblies
Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and drip
pans (if so equipped) can be lifted off, making them
easy to clean.
The electrode of
the spark igniter is
exposed when the
burner head is
removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to knock
over hot cookware.
Burner Caps
Lift off when cool. Wash burner caps in hot, soapy water
and rinse with clean water. You may scour with a
plastic scouring pad to remove burned-on food particles.
Dry them in a warm oven or with a cloth—don't
reassemble them wet. Replace the burner caps.
28
CARE AND CLEANING
(on some models)
Grate
Burner Cap
Drip Pan
(on some models)
Burner Head
Electrode
Electrode
BE SURE ELECTRICAL POWER IS
DISCONNECTED BEFORE CLEANING ANY
PART OF YOUR RANGE.
Burner Heads
(on sealed burners only)
For proper ignition, make sure the small hole in
the section that fits over the electrode is kept open. A
sewing needle or wire twist-tie works well to unclog it.
The slits in the burner heads of your range
must be kept clean at all times for an even,
unhampered flame.
You should clean the surface burners routinely,
especially after bad spillovers, which could clog
these openings.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20-30 minutes. For more stubborn stains, use a
toothbrush.
Before putting the burner head back, shake out
excess water and then dry it thoroughly by setting
it in a warm oven for 30 minutes.
Replace the burner caps. Make sure that caps are
replaced on the correct size burner. There is one
small, 2 medium and one large cap.
small
medium
medium
large
medium
Make sure that caps are replaced on the correct size
burner. There is one small, 2 medium and one large cap.
small
large
Front of Range
Advertisement
