Beko DIN14C10 User Manual page 14

Preparation
Test Strip
a
b
Remove the Let the water
test strip from flow from your
its packing. tap for 1 minute.
To Adjust the Water Hardness
1. Turn on the machine by pressing On / Off key while pressing and holding the
Programme Selection key when the machine is in off position. Press and hold the
programme key until the water hardness level stored on your machine is displayed in
the program indicator. Start / Pause indicator will start flashing once the stored water
hardness setting is displayed.
2. By using Programme Selection key, adjust water hardness level according to the
hardness of the supply water. See "Water hardness level adjustment table" for correct
setting.
3. Select the water hardness level suitable to your machine from the Water Hardness
Level Adjustment Table by pressing the Delayed Start Key.
4. Press «Start/Pause/Cancel» key for once to store the level you have selected.
5. Start / Stop icon will light continuously when the new water hardness level is stored.
6. Press the On/Off button to turn off your machine.
Water Hardness Level Adjustment Table
Hardness English Water
Level Hardness °dE
1 Level
st
0-5
2 Level
nd
6-9
3 Level
rd
10-15
4 Level
th
16-19
5 Level
th
20-24
6 Level
th
25-62
If the hardness level of the water that you use is above 90 °dF (French standard for water
hardness) or if you are using well water, than it is recommended to use filter and water
purification devices.
* If the hardness level of the water that you use is below 8°dF (French standard for water
hardness), there is no need to use salt in your dishwasher. If this is the case, "No Salt
/35 EN
14
c
d
1 second
Take the test strip
Fill a glass with
out of the water and
tap water and
dip the test strip shake it.
into water for 1
second.
German Water French Water
Hardness °dH Hardness °dF*
0-4 0-8
5-7 9-13
8-12 14-22
13-15 23-27
16-19 28-34
20-50 35-90
e
f
Level 1
Level 2
Level 3
Level 4
1 minute
Level 5
Level 6
Hold for Set the water hardness level of your dishwasher
1 minute. according to the result shown by the test strip.
Water Hardness Level Indicator
Press the Programme Selection button to set the water hardness
level to P1 position.
Press the Programme Selection button to set the water hardness
level to P2 position.
Press the Programme Selection button to set the water hardness
level to P3 position.
Press the Programme Selection button to set the water hardness
level to P4 position.
Press the Programme Selection button to set the water hardness
level to P5 position.
No Lime
Very low lime content
Low lime content
Medium lime content
High lime content
Very High lime content
Dishwasher / User's Manual