QT-CD111/111C
• Resistor:
To differentiate the units of resistors, the symbol as K and M
are used: the symbol K means 1000 ohm and the symbol M
means 1000 kohm and the resistor without any symbol is an
ohm resistor. The resistor designated "Fusible" is a fuse type
resistor
• Capacitor:
To indicate the unit of capacitor, a symbol P is used: this
symbol P means micro-micro-farad and the unit of the capacitor
without such a symbol is microfarad. As to electrolytic capacitor,
the expression "capacitance/withstand voltage" is used.
(CH), (TH), (RH), (UJ): Temperature compensation
(ML): Mylar type
(P.P.): Polypropylene type
• The indicated voltage in each section is the one measured by
Digital Multimeter between such a section and the chassis
with no signal given.
REF. NO
DESCRIPTION
SW102
RECODE/PLAYBACK
SW201
FUNCTION/POWER
SW203
X-BASS
SW601
TAPE MAIN
SW702
PICKUP IN
NOTES ON SCHEMATIC DIAGRAM
POSITION
OFF—ON
TAPE—AM—
FM AUTO—CD/
OFF—ON
OFF—ON
OFF—ON
OFF—ON
FRONT
VIEW
E C B
(S) (G) (D)
(1) (2) (3)
2SC1815 GR
Figure 16 TYPES OF TRANSISTOR
– 16 –
1. Tuner
( ): AM mode
Marking except for ( ): FM mode
2. CD
( ): Play mode
Marking except for ( ): Stop state
3. Deck section
( ): Record mode
Marking except for ( ): Playback mode
Display / Control section:
( ): Active state
Marking except for ( ): CD Function mode at stop state
• Schematic diagram and Wiring Side of P.W.Board for this
model are subject to change for improvement without prior
notice.
• Parts marked with "
" (
maintaining the safety of the set. Be sure to replace these
parts with specified ones for maintaining the safety and
performance of the set.
REF. NO
DESCRIPTION
SW761
CD LID OPEN/CLOSE
SW771
PLAY/REPEAT
SW772
STOP
SW773
TRACK UP/CUE
SW774
TRACK DOWN/REVIEW
) are important for
POSITION
OFF—ON
OFF—ON
OFF—ON
OFF—ON
OFF—ON
Need help?
Do you have a question about the QT-CD111 and is the answer not in the manual?
Questions and answers
Van-e külső antenna csatlakozási lehetőség vagy lehet-e erősít csatlakoztani
The Sharp QT-CD111 has an FM telescopic rod aerial, but there is no mention of an option for connecting an external antenna or a signal booster.
This answer is automatically generated
CD-Player unterbricht die Funktion (bricht Spielbetrieb ab) CD ist neu. Linse wurde schon gereinigt.
If the Sharp QT-CD111 CD player stops functioning even with a new CD and a cleaned lens, possible causes include issues with the DPS microcomputer (IC701), power supply, 4.19 MHz and 16.93 MHz clocks, or the reset terminal. Additionally, the waveforms of SCK, SO (DATA), and SI should be checked.
This answer is automatically generated