Basic Operation - Sharp PN-Y556 Operation Manual

2
5
6
9
10
1. INPUT (Input mode selection)
The menu is displayed. Press
ENTER
mode, and press
* You can select the input terminal by pressing the input
button of the monitor.
Input mode
DVI-D
HDMI[PC]
HDMI[AV]
D-SUB[RGB]
D-SUB[COMPONENT]
D-SUB[VIDEO]
Media Player
* DVI mode in which the HDMI signal does not include an
audio signal.
In the following cases, the input mode automatically changes
to "Media player".
• When a USB flash drive or SD memory card is connected
in the power ON state.
• When the power is turned on (the power ON state is
entered) with a USB flash drive or SD memory card
connected.
2. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.
3. MENU
Displays and turns off the menu screen. (see page 27.)
20
E

Basic Operation

1
3
4
7
8
or to select the input
to enter.
Video Audio
DVI-D input
PC audio input terminal
terminal
HDMI input HDMI input terminal /
terminal PC audio input terminal
PC audio input terminal
D-sub input
terminal
AV audio input terminal
USB port /
USB port / SD card slot
SD card slot
4. VOL +/- (Volume adjustment)
Pressing or displays the VOLUME menu when the
menu screen is not displayed.
Press or to adjust the volume of the sound.
* If you do not press any buttons for about 5 seconds, the
VOLUME menu automatically disappears.
* When the input mode is "Media Player", the volume can be
adjusted during auto play and schedule play. During any
other type of playback, use "Settings during playback" to
change the volume. (See page 25.)
5. BRIGHT +/- (Brightness adjustment)
Pressing or displays the BRIGHT menu when the
menu screen is not displayed.
Press or to adjust the brightness.
* If you do not press any buttons for about 30 seconds, the
BRIGHT menu automatically disappears.
*
6. ENTER
Confirms the setting.
7. RETURN
Returns to the previous screen.
8. SIZE (Screen size selection)/Yellow
Each time you press this button, the screen size changes in
the following order: (See page 21.)
NORMAL → WIDE → Dot by Dot →NORMAL...
9. DISPLAY/Red
Displays monitor information (Input mode, LAN Setup, etc.).
The display disappears automatically after about 15 seconds.
15
31