Tenda F303 Manual page 28

default WAN Medium Type is Wired WAN, so no settings are
required here if you connect to your ISP via an Ethernet cable. If
you connect to your WISP wirelessly, do as follows:
1. Select Wireless WAN and enable the scan feature.
!
2. Select the wireless network you wish to connect, say, Tenda_office,
and click OK. Then close scan.
!
3. 1). Verify that SSID and channel on this page are exactly the same as
they are on the uplink wireless network you just selected.
2). Configure the same security mode, security key, cipher type (or
WPA Algorithm) as they are on the uplink wireless network you just
selected. Click OK.