Fitting The Microphone - Panasonic WX-LT350 Operating Instructions Manual

Fitting the microphone

When fitting, removing, or adjusting the position of the microphone, turn off the power of the
microphone, and make sure that the microphone is not connected to the charger.
1
Hang the microphone around the neck
of the speaker.
Widen the looped part of the strap above
the microphone and hang it around the
speaker's neck, with the front of the
microphone facing outward as shown in
the illustration at right.
2
Adjust the position of the microphone.
While holding the lower end of the neck
strap with one hand and opening the clip
at the rear of the microphone with the
other, pull up the microphone to the level
of the speaker's chest.
Adjust so that the distance between the
speaker's mouth and the microphone
opening is approx. 15 cm {5-15/16"} as
shown in the illustration at right.
Let go of the clip in the desired position.
If bothered by the sound of the microphone rubbing against your clothes, fix the clip at the rear
of the microphone to your shirt pocket or placket.
Note:
• The infrared emitter is located only on the microphone
front. To prevent the sound from blocked or interrupted, do
not cover the infrared emitter with hands, clothes, or labels,
etc.
• The neck strap is provided with a safety closure to prevent
strangling. It is not meant to fit the microphone.
• To remove, reverse the above procedure.
14
Closure
Microphone opening Microphone opening Microphone opening
Side view
Hold
Clip
15 cm
{5-15/16"}
Microphone opening
WX-LT350
BATT CHG
PWR
WX-LT350
BATT CHG
PWR
Infrared emitter
WX-LT350
CHG
BATT
PWR
Hold Hold Hold