Operation; Using The Thermostat - Prem-I-Air EH1404 Manual

OPERATION

Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 6 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket, and at the switch on
the side of the heater.
Do not touch the air output grille when the heater is in
operation, because it will be hot and may cause burns.
Unplug the heater from the mains when not in use.
Select the required operation on the rotary control:
Select the "snowflake" symbol for "frost-stat" operation. In
this mode, the heater will operate only when the temperature
drops below 5°C, to prevent freezing.
Select the "sun" symbol for normal operation. In this mode,
the thermostat can be used to set the room temperature.
Select the "crescent moon" symbol for night-time operation.
This reduces the temperature by 2°C from normal operation,
without having to readjust the thermostat.

USING THE THERMOSTAT

The thermostat can be use to regulate the room temperature.
Turn the heater on, and rotate the temperature control fully
clockwise.
The heater will then operate at maximum output. When the
desired temperature is reached, rotate the temperature
control anticlockwise until a click is heard. The heater will
then switch on and off to keep the room at the desired
temperature.
Page 5