Joyner JNSZ650DL Owner's Manual page 23

Parts manual
Hide thumbs Also See for JNSZ650DL:
Table of Contents

Advertisement

engine oil as above.
b. Check the engine oil level, change if necessary from d as above.
C. Transmission lubrication
You must change the oil in the transmission after the first 5 hours of operating of your
new engine and after 10 hours of use thereafter. That will insure proper lubrication of
internal parts and prevent costly repairs due to excessive wear.
Figure 14
a. Put the vehicle on the level ground.
b. Shut down the engine, put a collecting oil plate under the transmission oil outlet.
Loosen the oil outlet plug in the warm engine. Let the transmission oil out fully (see
Fig. 15).
c. Remove the iron dust plug, this plug has a magnet on it. Iron dust caused by moving
parts will stick to the plug. Clean the iron dust from this dust plug.
d. Tighten the transmission oil outlet plug and the iron dust plug.
e. Remove dipstick of transmission (see Fig. 14), fill oil (GL-4 85W/90) about 1.9
liters.
f. Insert the transmission dipstick, check the oil level in the transmission. Confirm the
corrective oil level in the transmission (see Fig. 14).
Check transmission oil
If the color of transmission oil changes, you need to replace oil. Replace transmission
oil as above.
SERVICE INSTRUCTIONS
D. Engine Coolant
You must check the coolant for level and leaks. If it is low, you need to refill coolant
Figure 15
22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents