Table of Contents
Advertisement
Connecting to your computer network- cont.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Press the '123' button, then press
again when it shows 'hex'. This provides a simplified keyboard layout for the WEP key entry.
Some wireless routers can also use pass-phrases for WEP but these are not supported.
WPA keys are usually set up using a pass-phrase of between 8 and 63 characters. Your radio
accepts pass-phrases for WPA keys.
19. To enter the WEP or WPA key, characters see page 11. Enter characters as needed until the
complete key has been entered. Remember, WEP keys only use the numbers 0-9 and letters
A-F. WPA keys are sensitive to upper and lower case characters. You must enter the key exactly
or the radio will not connect to the network. After the final character of the WEP or WPA key
has been entered touch the tick symbol. The screen will show 'Connecting...' and then 'Setup
wizard completed'. Touch OK to exit the setup wizard. The radio should now be able to connect
to the network.
20. Once you have connected your radio to the network (and therefore also to the Internet) it will
go into Standby mode. It should then display the time as obtained from the Internet. If the time
display is not correct for any reason, it can easily be adjusted manually later, see the section
for 'manually setting the clock.'
If you have followed the steps on the preceding sections successfully, your radio will have
connected to your router, and then made a connection to the Internet and set its clock. If this
is the case, then you can try listening to radio stations via the Internet as described in the
section of 'Internet Radio' onwards.
Network key:
I
123 - JONES
Q
W
E
R
T
Y
U
A
S
D
F
G
H
J
Z
X
C
Q
B
N
M
123
Setup Wizard
15:09
23 Jun 2010
Setup wizard completed.
OK
Setup Wizard
15:10
Monday 8 Aug
I
O
P
K
L
.
Advertisement
Table of Contents
