Sangean WFR-2D User Manual page 14

Connecting to your computer network-cont.
If your network allows automatic configuration (which is normal) the radio will acquire a network
address. The screen should say 'Connecting,' and then 'Setup Wizard completed.' Touch OK to
exit the setup wizard, the radio will enter Standby mode. You can then skip to step 20 .
There are two indicator lights incorporated into the RJ-45 connector. If you have problems with
your wired connection, they may help you to identify the possible cause of the problem.
Yellow ON= Link established ; OFF =no connection
Yellow Flashing= Data transfer
Green ON= 100 Mbits/ sec link; OFF= 10 Mbits/ sec link
If your network does not support automatic configuration or if you wish to set it up manually then
you should select Manual Settings instead of selecting Wired in the Network Wizard, then see
the section of 'Manual network configuration.'
13. If you plan to use a WiFi connection, you will first need to identify your network in the list of
network names presented by the Network Wizard. If no networks are found then you may have
to get your wireless router working (please see the instructions supplied with it) or you may be
too far from the router. When the radio finds your wireless network, it displays the Network
Name (SSID) for the wireless access point on the screen. This is a name that is allocated to
the access point in your router by the person who set up the network-for example' Jones
family' or 'Paul's network.' If the router supports WiFi Protected Setup, then '[WPS]' will be
shown in front of the SSID. It is possible, and in some locations highly likely, that your radio
will find more than one wireless network, in which case you should choose which one you need
to connect to.
14. Scroll through the list to see the SSID for each wireless network that has been found. If your
network is shown proceed to step 16 on the next page. If it is not shown then proceed to step 15.
If you make a mistake at any point, use the Back button to go back to the previous screen.

15:09 23 Jun 2010
Setup wizard completed.
OK
00:00
Setup Wizard
Network Wizard
<WPS>
<Rescan>
<Wired Network>
Manual settings
00:00
Setup Wizard
Network Wizard
Smith
Jones
<WPS>
<Rescan>
Setup Wizard