Table of Contents
Advertisement
10.2 Indoor Unit
10.2.1
How to Fix Installation Plate
The mounting wall shall be strong and solid enough to prevent it from the vibration.
PS36***
The center of installation plate should be at more than
The distance from installation plate edge to ceiling should more than
From installation plate center to unit's left side is
From installation plate center to unit's right side is
○
B
: For left side piping, piping connection for liquid should be about
: For left side piping, piping connection for gas should be about
1
Mount the installation plate on the wall with 5 screws or more (at least 5 screws).
(If mounting the unit on the concrete wall, consider using anchor bolts.)
o
Always mount the installation plate horizontally by aligning the marking-off line with the thread and using
a level gauge.
2
Drill the piping plate hole with ø70 mm hole-core drill.
o
Line according to the left and right side of the installation plate. The meeting point of the extended
line is the center of the hole. Another method is by putting measuring tape at position as shown in the
diagram above. The hole center is obtained by measuring the distance namely 128 mm for left and
right hole respectively.
o
Drill the piping hole at either the right or the left and the hole should be slightly slanting to the outdoor
side.
10.2.2
To Drill a Hole in the Wall and
Install a Sleeve of Piping
1
Insert the piping sleeve to the hole.
2
Fix the bushing to the sleeve.
3
Cut the sleeve until it extrudes about 15 mm
from the wall.
When the wall is hollow, please be sure to use the
sleeve for tube assembly to prevent dangers
caused by mice biting the connection cable.
4
Finish by sealing the sleeve with putty or
caulking compound at the final stage.
B
Model
631mm
CAUTION
Dimension
95mm
581mm
at right and left of the wall.
.
.
.
21
41
581mm
195mm
255mm
from this line.
from this line.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
