If The Kettle Does Boil Dry; Filter Instructions; Filter Removal/Cleaning/Refitting - Oster BVSTKTVT01 Series User Manual

kettle has reached it's desired temperature, the heat water icon (
flashing.
If the temperature is set and you wish to change it, you will have to turn off
the kettle and switch it back on. As soon as the kettle reaches the desired
temperature, it will shut off automatically (unless the Keep Warm function has
been activated). The heat water icon (
water temperature will be displayed on the LCD panel.

IF THE KETTLE DOES BOIL DRY

If the kettle is operated in accordance with instructions for use, it is unlikely
that the kettle will boil dry. However, in the event that the kettle does boil dry,
it is protected by a boil dry, fail-safe device which will switch the kettle off
automatically on sensing a boil dry situation and keep it switched off until the
kettle is refilled with at least the minimum amount of water. Always allow the
kettle to cool for half an hour before reuse if the kettle has boiled dry.

Filter instructions

A mesh filter has been integrated into the kettle to reduce the amount of scale
residues entering your beverages or food. The filter is removable for cleaning.
To reduce scale build-up, empty out any residual water after boiling.
How often the filter should be cleaned will vary according to where you live
and how often you use your kettle. Filter should be cleaned whenever there
are noticeable deposits left on the filter and especially if the rate of pouring
decreases.

Filter removal/cleaning/refitting

Important: The kettle must be switched off, disconnected from the power
outlet and allowed to cool down completely prior to removing or refitting the
filter. Do not use excessive force, as this might damage the filter or the lid.
1. Empty the kettle and lift lid.
2. Grip the top part of the filter with index finger and thumb and pull
upwards. You may have to hold the kettle while removing the filter.
Caution: Keep fingers clear of mesh. Pressing into mesh may damage
filter.
3. To clean the filter, rinse under a tap while brushing it gently with
a soft brush.
4. To refit filter, once again hold the filter with index finger and thumb.
Gently push the filter back into the kettle until you hear a click. The filter
is now reattached. Gently tug on filter to ensure filter is attached properly.
5. Rinse out kettle with fresh water and it's ready for use.
REMOVE
6
BVSTKVT01-033_14EFM1.indd 11-12
) will stop
) will stop flashing and the current
REFIT
6/17/14 1:40 PM