If The Kettle Does Boil Dry; Filter Instructions - Oster BVSTKT7004 Instruction Manual

Your kettle is fitted with standby illumination that lights the water level window with everchanging
mood lighting. The standby illumination will go out after approximately 20 minutes.
To restart the standby illumination do one of the following:
1. Lift the kettle off the power base and replace it again.
2. Unplug the kettle then plug it back in again.
3. Boil the kettle as normal.
To switch off the standby illumination, remove kettle from base or remove the plug from
wall socket.
WATER LEVEL WINDOW WITH COLOR
CHANGING TEMPERATURE INDICATOR
When your kettle is powered on, water level illumination switches from standby to
temperature indicator mode. In this mode, color shown in water level window represents
water temperature as follows:
Water Level
Window Color
Approx. Water
Temperature

IF THE KETTLE DOES BOIL DRY

If the kettle is operated in accordance with instructions for use, it is unlikely that the kettle
will boil dry. However, in the event that the kettle does boil dry, it is protected by a boil dry,
fail-safe device which will switch the kettle off automatically on sensing a boil dry situation
and keep it switched off until the kettle is refilled with at least the minimum amount of
water. Always allow the kettle to cool for half an hour before reuse if the kettle has boiled dry.
A mesh filter has been integrated into the kettle to reduce the amount of scale residues
entering your beverages or food. The filter is removable for cleaning. To reduce scale
build-up, empty out any residual water after boiling.
How often the filter should be cleaned will vary according to where you live and how often
you use your kettle. Filter should be cleaned whenever there are noticeable deposits left
on the filter and especially if the rate of pouring decreases.
STANDBY ILLUMINATION
Sky Blue
32 ºF - 80 ºF

FILTER INSTRUCTIONS

Blue
140 ºF
En gli sh - 5
Violet Red
170 ºF 200 ºF