Table of Contents
Advertisement
■
[
AUTO SWITCHING
This function automatically identifies wide signal
16:9/4:3 and automatically recalls memory settings
that have been set for each screen size.
*1 : Wide signals are 2.35:1,
2.40:1, 2.50:1, 2.55:1 aspect signals.
SCREEN AREA MEMORY AUTO SWITCHING
2.35:1 IMAGE DETECTION
PICTURE
16:9 IMAGE DETECTION
POSITION
LANGUAGE
OPTION
1)
Use the ▲▼ buttons to select the item
for automatic identification.
2)
Press the ◄ ► buttons to select
the required memory for automatic
identification.
The memory setting which has been selected for
z
[2.35:1 IMAGE DETECTION] is loaded after a
given period of time once the input signal switches
from 16:9/4:3 to 2.35:1.
The memory setting which has been selected for
z
[16:9 IMAGE DETECTION] is loaded after a given
period of time once the input signal switches from
2.35:1 to 16:9/4:3.
If [OFF] is selected, automatic identification will not
z
be performed.
This function is not available when [ZOOM] or
z
[V-FIT] is selected from the [ASPECT] menu.
Note
If the memory is not registered using [MEMORY SAVE] in
z
the [SCREEN AREA MEMORY] menu, you cannot select
[AUTO SWITCHING].
When displaying the menu or test pattern, automatic
z
identification is not performed.
Images may not be correctly recognized if there is noise
z
in the picture or external device generates noise. Image
size may also not be correctly recognized depending on
the video.
Image size may not be correctly recognized if the input
z
signal level from the external device is not set to the
suggested value range. In this case, adjust the input
signal level using the [WAVEFORM MONITOR] menu.
(
page 39)
Image size may not be correctly recognized if the screen
z
position is not correctly adjusted.
In this case, adjust the screen position using the
[POSITION] menu. (
page 55)
]
*1
or
OFF
OFF
[POSITION] menu
■ [
H-AREA POSITION
You can move the frame area horizontally, such as
aligning the right or left frame edge to the screen
edge.
Moving left
For example, when projecting an overscanned 16:9
projection area at a 4:3 aspect ratio on a 4:3 aspect
screen, you can adjust the horizontal discrepancy
between the screen position and the video display
position.
16:9 projection area
4:3 video display position
■
[
V-AREA POSITION
You can move the frame area vertically, such as
aligning the top or bottom frame edge to the screen
edge.
Moving
downward
For example, when projecting an overscanned 16:9
projection area at a 2.35:1 cinema scope screen
movie on a 2.35:1 size cinema scope screen, you can
adjust the vertical discrepancy between the screen
position and the video display position.
2.35:1 cinema scope screen
16:9 projection area
size video display position
2.35:1 cinema scope screen
]
Moving right
4:3 screen
]
Moving upward
ENGLISH - 61
Advertisement
Chapters
Table of Contents
