Operation - CrimeStopper CS-882.OEM Install Manual

OPERATION

PASSIVE ARMING MODE (Programmable Option)
When programmed for Passive (Automatic Last Door Arming) the CS-882 will arm itself 30 Seconds after the
ignition is turned off and the last door has been closed. If a door is reopened, the system will wait for the door to
close before arming.
DUAL-STAGE SHOCK PROTECTION
If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 1 siren/horn chirp
and one light flash. If a hard impact to the vehicle occurs, the system will trigger for 30 seconds. Adjust the shock
sensor as needed by turning the control knob clockwise to increase sensitivity and counter-clockwise to decrease
sensitivity.
EMERGENCY OVERRIDE/DISARM
If the CS-882 system is armed and you have lost your Factory Keyless Remote or it stops working, you will have to
perform an emergency override. Enter your vehicle manually with the key, (this will trip the alarm) turn the Ignition
ON, and press override/program button 5 times within 8 seconds to disarm the system. The system will chirp/flash
4 times when disarmed.
PANIC MODE (Programmable Option)
To activate your system during an emergency situation or to attract attention to your vehicle, press the Lock button
on your remote 3 times within 5 seconds. This will activate a 30-second alarm trigger. Press any button on your
remote to disarm.
VALET MODE
To disable alarm functions of the 882 system, turn the Ignition ON and press the override/program button 3 times
within 8 seconds. After 8 seconds, the dash L ED turns on solid as an indicator that the system is in valet mode.
Repeat this steps to exit VALET mode. The LED will go out, system will chirp (2) times and the light will flash (2)
times when exiting valet mode.
When in VALET mode the siren will still chirp for lock/unlock confirmation even though alarm functions are disabled.
The CS-882 system will chirp 2 times and flash the lights twice when locking the doors. The system will chirp 3
times and flash 3 times when unlocking the doors.
OPEN DOOR WARNING (Programmable Option)
If a door is open when the Ignition is on the 882 system will flash the parking lights for up to 1 minute or until the
door is closed as a "Door open" safety feature.
FACTORY TRUNK RELEASE SENSING
If the CS -882 system is installed in a vehicle with trunk pop or hatch release button on the Factory Remote, there is
a special input wire that will prevent the system from triggering if the trunk button on your remote is pressed while
the system is armed.
INSTALLATION – ARM/DISARM MODES (SWITCH SETTINGS)
ARM/ DISARM VALIDATION WITH NEGATIVE SIGNALS:
ARMING: To Arm the CS-882 OEM the system MUST sense a Negative
(TOP EDGE OF 882 MODULE)
pulse on the GREEN/WHITE, validation wire when the vehicles. Door
LOCK Button is pressed.
DISARMING: To Disarm, the CS-882 OEM system MUST sense a
1 2 3 4
O N
Negative pulse on the RE D/WHITE validation wire when the vehicles
NEGATIVE VALIDATION INPUTS
Factory UNLOCK button is pressed. See switch setting at right. >>>
ARM/ DISARM VALIDATION WITH POSITIVE SIGNALS:
Same as above, however the CS-882 system MUST sense Positive
signals for ARM/DISARM. See switch settings at right. >>>
(TOP EDGE OF 882 MODULE)
VALIDATION WIRES ON (MODE A = DIP SWITCHES 1-3 ON):
1 2 3 4
The Validation wires serve as a secondary input to prevent the system
O N
from being armed or disarmed simply by pushing the unlock button on the
POSITIVE VALIDATION INPUTS
vehicle.