Axis P3304 User Manual page 52

AXIS P3304 Fixed Dome Network Camera
Troubleshooting
Lower frame rate than
expected
Status and Network indicator LEDs are flashing red rapidly
Hardware failure
Video and image problems, general
Image unsatisfactory
Motion Detection triggers unexpectedly
Changes in luminance
No audio
Incorrect setup
Poor audio quality
Stuttering
Unsynchronized audio and
video using H.264
Distorted audio
Feedback loops
See Performance Considerations on page 55.
Reduce the number of applications running on the client computer.
Limit the number of simultaneous viewers.
Check with the network administrator that there is enough bandwidth available.
Check in the AMC Control Panel (H.264 tag) that video processing is NOT set to Decode only
key frames.
Lower the image resolution.
Contact your Axis reseller.
Check the video stream and camera settings under Setup > Video & Audio > Video Stream and
Setup > Video & Audio > Camera Settings.
Motion detection is based on changes in luminance in the image. This means that if there are
sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
setting to avoid problems with luminance.
Check the sound card in the computer. Ensure that mute is not selected and that the volume
settings are correct.
Check that Enable audio support is selected under Setup > System Options > Security > Audio
Support.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Reduce the number of listeners and viewers. Decrease image resolution and compression.
Synchronize the product's date and time settings with an NTP server. Go to Setup > System
Options > Date & Time.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Feedback loops might appear in full-duplex mode. Try moving the microphone or the speaker, or
use half-duplex mode instead.
52