Sharp LC-32L450X Operation Manual page 15

Setup menu (Continued)
Parental rating
This function allows TV channels to be restricted.
It prevents children from watching violent or sexual
scenes that may be considered inappropriate.
Repeat steps 1 to 3 in Setting a password.
1
Press a / b to select "Parental rating", and
2
then press ENTER.
Press a / b to select your desired rating, and
3
then press ENTER.
When the country setting is set to "Australia".
Selected item
General and Content is not offensive to most viewers.
above (G)
Parental Content is such that parents may not want
guidance and their children to view the programme.
above (PG)
Mature and Mature audience only. This programme is
above (M) specifi cally designed to be viewed by adults
and therefore may be unsuitable for children
under 15.
Mature adult Mature adult only. Mature audience only.
and above This programme is specifi cally designed to
(MA)
be viewed by adults and therefore may be
unsuitable for children under 15.
Adult violence Not for children under age 15. Strong
and above elements of sex and/or violence.
(AV)
Restricted Not for children under age 18. Strong
and above (R) elements of sex and/or violence.
No block (–) Cancel the blocking.
When the country setting is set to "New Zealand" or
"Singapore".
Block 5 age and below
Block 11 age and below
Block 13 age and below
Block 15 age and below
Block 17 age and below
Block 18 age and below
No block
H Input skip
This setting allows you to skip the HDMI or RGB input
on the input source selection operation.
INPUT1(HDMI)
INPUT2(HDMI)
INPUT3(HDMI)
INPUT7(RGB)
Description
Skip input selection of HDMI
Yes No
H Input label
You can assign each input source a label as you
prefer.
Press TV/VIDEO to select the desired input
1
source.
Press MENU and the MENU screen displays.
2
Press c / d to select "Setup".
3
Press a / b to select "Input label", and then
4
press ENTER.
Press a / b / c / d to select a desired
5
alphanumeric, and then press ENTER.
Repeat until the name is fully spelt out.
Maximum 6 alphanumeric can be input.
External equipment name settings
A B C D E F G H I J
KLMNOPQRST
U V W X Y Z + – . _
0 1 2 3 4 5 6 7 8 9
To exit, select END and then press ENTER.
If the wrong alphanumeric is entered, select
CLEAR to clear, and then press ENTER.
NOTE
• You cannot change labels if the input source is ATV and
DTV.
H Position
For adjusting a picture's horizontal and vertical
position.
Selected item
H-Position Centres the image by moving it to the left
or right.
V-Position Centres the image by moving it up or
down.
Reset Reset position to factory preset values.
H HDMI auto view (HDMI input mode only)
Selected item
Enable/ Set whether or not to use WIDE MODE
Disable based on signal recognition, including an
HDMI signal.
H WSS
WSS allows a television to switch automatically among
the different screen formats. (On, Off)
NOTE
• Try to set WIDE mode if an image does not switch to the
correct screen format. When the broadcast signal contains
no WSS information, the function will not work even if
enabled.
• Not available for COMPONENT, PC and HDMI signal.
CLEAR
BACK
END
Description
Description
13