Napoleon Ultra chef UD405RSB User Manual page 10

Hide thumbs Also See for Ultra chef UD405RSB:
Table of Contents

Advertisement

Available languages

Available languages

10
Cleaning: Use a flexible venturi tube brush to clean the inside of the burner. Shake any loose debris from the
burner through the gas inlet. Check the burner ports and valve orifices for blockages. Burner ports can close
over time due to cooking debris and corrosion, use an opened paperclip or the supplied port maintenance bit
to clean them. Drill out blocked ports using this drill bit in a small cordless drill. The ports are easier to clean
if the burner is removed from the grill, but it can also be done with the burner installed. Do not flex the drill
bit when drilling the ports, as this will cause the drill bit to break. This drill is for burner ports only, not for the
brass orifices (jets) which regulate the flow into the burner. Take care not to enlarge the holes. Ensure the
insect screen is clean, tight, and free of any lint or other debris.
Reinstallation: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace sear plate mount and tighten screws to complete reinstallation.
WARNING!
that the valve/orifice enters the burner tube before lighting your gas grill. If the
valve is not inside the burner tube a fire or explosion could occur.
WARNING!
exist, do not use the gas grill. Have the part replaced by your Ultra Chef Gas Grill dealer or qualified gas
installer.
Aluminum Castings: Clean castings periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidation to occur on aluminum surfaces. This appears as white spots
on the castings. To refinish these areas, clean first and sand lightly with fine sandpaper. Wipe the surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding areas from over-spray.
Follow the manufacture's directions for curing.
www.ultrachefgrills.com
When reinstalling the burner after cleaning it is very important
Hose: Check for abrasions, melting, cuts, and cracks in the hose. If any of these conditions

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents