License Plate Lamp - GMC Chevrolet Tahoe 2011 Owner's Manual

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Power) on page 2 10 or Liftgate
(Manual) on page 2 12.
2. Remove the two screws from
the taillamp assembly.
3. Pull the taillamp assembly
rearward disengaging the
two outer pins on the taillamp
assembly from the vehicle.
4. Turn the bulb socket
counterclockwise to remove it
from the taillamp assembly.
5. Pull the old bulb straight out
from the bulb socket.
6. Press a new bulb into the bulb
socket and install the socket into
the taillamp assembly by turning
it clockwise.
7. Reinstall the taillamp assembly.
When reinstalling, make sure to
line up the pins on the taillamp
assembly with the vehicle.
If this is not done, the taillamp
assembly will not be able to
be installed correctly.
Vehicle Care

License Plate Lamp

1. Remove the two screws holding
each of the license plate lamps
to the molding that is part of the
liftgate.
2. Twist and pull the license plate
lamp assembly forward through
the molding opening.
3. Remove the bulb socket from
the lamp assembly by turning it
counterclockwise.
10-37