Table of Contents
Advertisement
Tour Between Points
Multiple preset points can be connected to create "tour lines". The PTZ camera can be
programmed to cruise a set of presets along a specified line.
a. Using the direction control buttons move the camera to a desired point.
b. Click the SET button on the PTZ Control interface screen.
c. Using the screen below as an example, click the TOUR button, and use the left mouse
button and soft keyboard to enter the preset point and the tour line number (PATROL
NO.). Then click ADD PRESET.
d. To set the interval or dwell time (time the camera will remain on a preset point before
moving to the next point) enter the desired value in the INTERVAL field.
e. Repeat the above steps until all presets are added for each tour line (Patrol Line) under
Tour.
f.
To remove a preset, enter the preset value and click the DEL PRESET button.
g. To remove a tour line, enter the Patrol No. value and click the DEL TOUR button.
h. To call a tour from the PTZ Control interface screen click the PAGE SWITCH button once
to display a page for calling presets, patterns, tours, and scans. The control page
displayed will be similar to the one below.
v2.0 11/8/11
36
Advertisement
Table of Contents
