Add And Register A Headset - VTech DS6670-6C User Manual

Appendix

Add and register a headset

The telephone system accommodates up to two cordless headsets. You can add
a new headset (IS6100, purchased separately) to your telephone system. The
headset must be registered with the telephone base before use. You may need to
charge the headset before registering it to the telephone base. For more details on
headset charging, see page 5.
To register a headset:
1. Place the non-registered headset in the
telephone base and allow it to charge for at
least 15 minutes before beginning registration.
Remove the headset from the telephone base.
The light on the headset flashes slowly and
alternately in red and blue.
2. On the telephone base, press and hold
FIND HANDSET for about four seconds until
the red IN USE light turns on.
3. Immediately place the headset in the telephone base. It takes about 60 seconds
to complete the registration. The red IN USE light on the telephone base turns
off. The light on the headset turns red when it is registered but not fully
charged, or turns blue if it is registered and fully charged.
If registration is successful, you hear a dial tone when you press
If registration fails, you hear "Not registered" through the headset earpiece
when you press
alternately in red and blue. To reset the headset, remove it from the telephone base
and then place it back into its charger. Try the registration process again.
The headset must be deregistered before registering it to another telephone system.
on the headset. The light on the headset flashes slowly and
75
The light
on the headset.