Table of Contents
Advertisement
Getting started
Handset battery installation
Install the battery as shown below.
1.
Plug the battery connector securely
into the socket inside the handset
battery compartment, matching the
orientation of the engraved label.
3.
Align the cover flat against the battery
compartment, then slide it towards the
center of the handset until it clicks into
place.
•
If the handset will not be used for a long time, disconnect and remove the battery
to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
•
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
IMPORTANT:
Check for a dial tone by pressing
installation is successful.
If you do not hear a dial tone:
•
Make sure the installation procedures described above are properly done.
•
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service
provider for more information.
2.
Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
4.
Charge the handset by placing it in the
telephone base or handset charger.
The CHARGE light is on when the
handset is charging.
CHARGE
remains on
when charging.
/HOME,
CELL 1 or
3
light
CELL 2. If you hear a dial tone, the
Advertisement
Table of Contents
