List Of Picture In Picture; Serial Control Interface - Christie LWU505 User Manual

DVI
o : Picture in Picture combinations are enabled.
x : Picture in Picture combinations are disabled.
Note:
• When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.
• Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered
or images may not be displayed on the Main/Sub picture.
<Display resolution is lowered when;>
• Inputting PC analog signals: Between 100-160 MHz
<Images are not displayed and X mark appears when;>
• Inputting PC analog signals: More than 160 MHz
• Inputting PC digital signals: More than 100 MHz
• Inputting AV digital signals: 1080p
<Picture in Picture is disabled when;>
• Inputting signal formats: WUXGA 1, WXGA+2, UXGA 1, UXGA 2, UXGA 3, UXGA4, D-1080p
This projector provides a function to control and monitor the projector's operations by using the RS-232C
serial port.
Operation
1 Connect a RS-232C serial cross cable to CONTROL
PORT on the projector and serial port on the PC.
(See p.19)
2 Launch a communication software provided with PC
and setup the communication condition as follows:
Baud rate : 9600 / 19200 bps
Parity check
Stop bit
Flow control
Data bit
3 Type the command for controlling the projector and
then press the "Enter" key.
Example
When you want to change the input to INPUT 2,
Type 'C' '0' '6' and press the Enter key.
LWU505 User Manual
020-000374-0

List of Picture in Picture

DVI

Serial Control Interface

: none
: 1
: none
: 8
Note:
The default of the baud rate is set to
19200 bps. If an error occurs in the
communication, change the serial port
and the communication speed (baud
rate).
Note:
Enter with ASCII 64-byte capital
characters and one-byte characters.
Appendix
89