DCS BG36-BQARN Use And Care Manual page 23

Using The Rotisse rie
TO LIGHT:
All BQR Series Only: The location of the rotis burner makes it more susceptible to strong wind
conditions, more so than the protected grill burners. For this reason you should avoid operating the
rotis during windy conditions. As an added safety feature we've equipped the burner with an automatic
safety valve which will not allow gas to flow to the rotis burner unless the following conditions are
present with the knob on:
1.The safety valve button is pressed, and held down.
2.The safety valve thermocouple has been sufficiently heated to keep safety valve open.
Open the lid. Push and hold the ignition button. You'll hear a snapping sound. Turn the control knob
to 'LITE'. Engage the safety valve button and continue to hold until the burner is lit. Once lit, turn
control knob to desired setting. If the burner does not light within 4 to 5 seconds, release the safety
valve button and turn the control knob to "OFF" and wait 5 minutes before trying again.
• If relighting a hot burner, wait 5 minutes.
• Never leave the control knob on if rotis is not in use.
• Never light a grill burner under the rotis while rotisserie burner is lit.
MANUAL LIGHTING:
To manually light the rotisserie, place a
butane lighter near the tip of the
thermocouple as shown in Fig. 25. Turn
the control knob to "LITE". Hold the
safety valve button in for about 4 to 5
seconds or until the burner remains lit.
Once lit, turn control knob to desired
setting. If the burner does not light
within 4 or 5 seconds, release the
safety valve button and turn the control
knob to "OFF" and wait 5 minutes
before trying again.
WARNING: Keep hands and face
away from front of
burner! Stand to the
side when lighting. Once lit move hand away quickly.
WARNING: Electrical Grounding Instructions:
This appliance (rotisserie motor) is equipped with a three-prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.
Do not cut or remove the grounding prong from this plug.
The Rotisserie motor must be electrically grounded in accordance with local codes or, in the absence
of local codes, with the National Electrical Code, ANSI/NFPA 70-1990. Keep the rotis motor electric
cord away from the heated surfaces of the grill. When not in use, remove and store the motor in a
dry location.
FIG. 25
22
Thermocouple