Advertisement
Take the horizontal mounting
bracket piece (piece with tabs
at top) and place it on the level
line you drew. Mark the holes
with a pencil and remove the
bracket. Using a ¼" drill bit, drill
the holes you just marked. Take
the white plastic anchor and tap
one into each drilled hole using
a hammer. Make certain the
anchor is flush with the wall.
Place the horizontal bracket on the wall in line
with the anchors and using the anchor screws
secure and tighten the bracket to the wall.
Hang the vertical brackets off each tab on the
horizontal bracket. Using a level, level each side
bracket and mark the holes.
Remove the bracket and drill
the newly marked holes. Tap
into each hole one plastic wall
anchor.
635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax 407-426-7721
http://shop.bluworldusa.com · www.nu-flame.com
Advertisement
