Kenmore 795.79012.901 Service Manual page 11

16. Following illustration, flip the Middle Bracket
(Flange will now be on top) and position on left side of
refrigerator and re-attach with two bolts and a Phillips
screw (fig.32).
17. Place refrigerator door down over pin on bottom
hinge (fig.32).
18. Place washer between refrigerator door and
middle hinge and re-attach Hinge Pin to Hinge Bracket
with 1/4-in socket wrench.
Note: Bracket has been flipped, but Hinge Pin stays in
the same orientation with its hexagonal end facing
upward (fig.32).
Fig. 32
Flange
19. Place Decorative Screw into outer hole on right
side of housing (fig.33).
20. Attach cover on the right side. Cover is force-fitted
(fig.33).
Fig. 33
Reattaching Freezer Door
1. Put freezer door down over the Hinge Pin on the
Middle Hinge Pin Bracket (fig.34).
2. Place Upper Hinge's Pin in the top of freezer door
and line up the Upper Hinge with holes in top of
refrigerator. Use the 3 bolts to replace Hinge (fig.35).
Middle Hinge
Bracket
Decorative
Screw
Fig. 34
- 11 -
Fig. 35
3. Tighten bolts. Force-fit Top Hinge Cover over Top
Hinge (fig.36).
Fig. 36
4. Replace cover from left side of refrigerator top onto
the right of top to cover the holes.
Cover is also force-fitted (fig.37).
Cover (on top of
refrigerator)
Fig. 37
After changing doors, make sure that the corners of the
Door Gaskets are not folded over.
To ensure a good seal, apply a small amount of silicon
grease on the corners of gaskets.
Corners