Kenmore 795.79012.901 Service Manual page 10

8. Move the Bottom Hinge to the left side of housing
keeping the same orientation, and reattach with 3 bolts
(fig.25). Now move Decorative Bolt to hole on lower
right side of housing.
Fig. 25
9. Turn refrigerator door upside down on a
non-scratching surface.
10. With door upside down, loosen the 2 screws and
remove the Door Closer/Stop (fig.26), then loosen the
other two screws to remove the bottom Hinge Pin
Insert Bracket with Hinge Pin Insert (see fig.27).
Fig. 26
Door Closer/Stop
Fig. 27
Hinge
Pin Bracket
Hinge Pin
Insert
11. Take out the Hinge Pin Insert and move the
Bracket to the other side of the door, keeping the same
orientation (fig.28).
12. Place Hinge Pin Insert into the left side of the
bracket. Tighten Hinge Pin Bracket to door (fig.28).
13. Take Door Closer/stop and flip (see fig.29).
Line up screw holes and mount on left side of door
bottom with the two screws. Turn door upright. It is now
ready for re-attaching.
Fig. 29
14. With flat-head screwdriver, carefully pry off and
remove the cover over the screw holes on the left side
of refrigerator housing (fig.30).
Fig. 30
15. Remove the outer lower Decorative Screw from
housing at area between freezer and refrigerator doors
(fig.31). (You will need this hole for the Middle Hinge
Bracket).
Fig. 31
- 10 -
Fig. 28
Hinge
Pin Bracket
Hinge Pin Insert