Brother ADS-2600W Quick Setup Manual page 24

For Wireless Network Users
One-push setup using
10
WPS or AOSS™
(Windows
a
Confirm your wireless access point/router has
the WPS or AOSS™ symbol as shown below.
b
Place the Brother machine within range of your
WPS or AOSS™ access point/router. The
range may differ depending on your
environment. Refer to the instructions provided
with your access point/router.
c
Press .
Swipe up or down, or press a or b to display
Network, and then press Network.
Swipe up or down, or press a or b to display
WLAN, and then press WLAN.
Swipe up or down, or press a or b to display
WPS/AOSS, and then press WPS/AOSS.
When Enable WLAN? is displayed, press Yes
to accept.
Note
If your wireless access point/router supports WPS
(PIN Method), you can also configure your
machine using the PIN (Personal Identification
Number) Method. uuNetwork User's Guide:
Configuration using the PIN Method of WPS
(Wi-Fi Protected Setup)
d
When the LCD shows to start WPS or AOSS™,
press the WPS or AOSS™ button on your
wireless access point/router. See the user's
guide of your wireless access point/router for
instructions.
Then press OK and your machine will now
automatically detect which mode (WPS or
AOSS™) your wireless access point/router
uses and try to connect to your wireless
network.
24
®
& Macintosh)
e
A connection result message appears until the
OK button is pressed on the LCD.
If your wireless device is connected
successfully, the LCD shows Connected.
If the connection failed, the LCD shows an
error code. Make a note of the error code, see
Troubleshooting on page 25, and correct the
error.
Wireless setup is now complete. A four
level indicator at the top of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 11.
®
For Windows users:
Now go to
Page 28
For Macintosh users:
Now go to
Page 31