Care And Cleaning - Zanussi ZKG 7125 User Manual

1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the selector dial to
the selected washing programme/fabric.
4. Select the required options by pressing the relevant
buttons.
Note!
If possible, do not select a spin speed lower than
that proposed by the appliance to avoid too long a
drying time therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
5. Select the drying time by pressing the button 4 or
dryness degree by pressing the button 3. The display
shows the entire duration of the washing and the se-
lected drying cycle.
Fluff in the garments
During the WASHING AND/OR DRYING PHASE, certain
types of fabric, as sponge-cloth, sweatshirt, could release
fluff.
The released fluff could stick to the fabrics during the next
cycle.
This drawback increases with technical fabrics.
To prevent the lint in your clothes, it is recommended:
• To do not wash dark fabrics after you washed and dried
light colored fabrics (new sponge, sweatshirt especial-
ly) and vice versa.

Care and cleaning

Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's instruc-
tions. This will help to prevent the formation of lime de-
posits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
16
6. Start the programme by pressing button 7. After the
programme has started, the time remaining is upda-
ted every minute.
7. At the end of the programme the buzzer sounds. A
flashing zero « » appear on the display. At this
point of the programme, starts an anti-crease phase
which lasts about 10 minutes. During this time the
door is locked and the display keeps showing the
flashing zero « ». (If you wish to open the door
before or during the anti-crease phase, please follow
the instructions given in the previous chapter).
8.
Turn the selector dial to the
the machine off.
9. Remove the laundry.
• To air-dry this type of fabrics when they are washed the
first time.
• To clean the filter.
• Perform one or more rinse cycles to wash the drum be-
tween the washing and drying of fabrics with different
colors.
• After the drying phase, thoroughly clean the empty
drum, the gasket and the door with a wet rag.
Cleaning the dispenser drawer
The washing powder and additive dispenser drawer
should be cleaned regularly.
position to switch