Table of Contents
Advertisement
At the end of the programme
The machine stops automatically. The blinking
on the display, the pilot light of button 7 and the pilot light
9 go off.
If a programme or an option that ends with water left in the
tub has been selected, the pilot light 9 remains on and the
door is locked to indicate that the water must be emptied
out before opening the door.
Before you empty out the water, the drum continues to run
at regular intervals until the water draining.
Follow the below instructions to empty out the water:
1.
Turn the programme selector dial to
Use - Drying
Drying only
The recommended load size is 3 kg for cottons and linen,
and 2 kg for synthetic items.
Note! By pressing Drying Time button it is also possible
to dry up to 4 kg of cotton items (see the «Drying Pro-
gramme» table).
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1.
Load the laundry.
2.
Select a spin cycle at the maximum spin speed al-
lowed for the type of laundry in order to obtain the
best drying performances.
3.
Select the drying programme for Cottons or Synthet-
ic in the Drying sector of the programme selector di-
al.
4.
If you wish to select an electronic drying, press the
button 3 until the pilot light corresponding to the re-
quired dryness degree illuminates.
5.
If you wish to select a timed drying, press button 4
until the time you want appears on the display (see
the «Drying Programmes» table). Every time you
press this button the drying time increases by 5 mi-
nutes.
Note!
The programme time will automatically increase by a
few minutes.
6.
Press button 7 to start the programme.
After the programme has started, the time remaining
is updated every minute.
Note!
2.
Select the draining or spinning programme.
3.
Reduce the spin speed if needed, by pressing the
appears
relevant button.
4.
Press button 7.
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
.
The different type of cottons (towelling, sheets,
shirts, and so on) or any laundry items rolling up
during the spinning phase may result in partial dry-
ness. In the exceptional case that at the end of the
cycle the laundry remains slightly wet, we suggest
that you unfold the rolled up items, redistribute them
evenly in the drum and select an additional drying
cycle of 20-30 minutes.
7.
At the end of the programme, the buzzer sounds and
a blinking «
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door is
locked and the display keeps showing the flashing
zero «
Note!
If you wish to open the door before or during the an-
ti-crease phase or to interrupt it, press any button or
turn the programme selector dial to any programme
position (except
few minutes.
8.
Turn the selector dial to the
the machine off.
9.
Remove the laundry.
Automatic washing and drying (NON-STOP programme)
For NON-STOP programmes, the recommended load size
is 3 kg for cotton and 2 kg for synthetic.
Note! It is possible to dry up to 4 kg of cotton items by
pressing Drying Time button only (see the «Drying Pro-
gramme» table).
Do not use a dosing device/ball when carrying out a
washing and drying programme.
» appear on the display.
».
), the door can be opened after a
position to switch
to
15
Hide quick links:
Advertisement
Table of Contents
