Yamaha Fazer Owner's Manual page 69

b. Spark Plug
c. Valve Clearance
d. Kick Operation
e. Carburetor
f. Drive Chain
g. Brake Fluid
h. Fasteners
SERVICE2.PMD 3
: Recommended No. (CR7HSA-NGK)
Gap
: (Cold condition)
(If required) Inlet
Exhaust
(After matching of the mark on sprocket cam chain with mark on Cylinder
Head Casting and ensuring the Piston at TDC of compression stroke.)
: For free Movement
: • Idle RPM
• Check for Overflow
: • Alignment
• Slackness
: • Fluid Level (Refer Page 6-18)
1. Cylinder Head Bolts
2. Engine Mounting
a) Engine Mounting Front and Stay Front
b) Stay Engine Front and Frame
c) Engine Mounting Rear and Frame
d) Engine Mounting Upper &
Stay Engine Upper
e) Stay Engine Upper and Frame
3. Front and Rear Silencer Mounting Nut
4. Crown Handle Centre Bolt
5.Starter Motor Mounting Bolts
PRE-DELIVERY INSPECTION REPORT
0.6-0.7 mm
0.08 ~ 0.12 mm
0.10 ~ 0.14 mm
1300~1500 RPM)
In warmed up condition (
(20 ~ 30 mm)
Specified Torque
(Ft-Lb)
14-17
25-29
25-29
25-29
25-29
25-29
9-12
8-14
6-7
10-3
10/1/2005, 12:57 PM