Configuring Network Settings; Configuring The Ip Address Settings Using The Control Panel - Ricoh SP 200SF User Manual

Configuring Network Settings

This section describes configuring the settings required to use the machine on a network.

Configuring the IP Address Settings Using the Control Panel

The procedure for configuring network settings differs depending on whether IP address information is
assigned automatically by the network (DHCP), or manually.
The IP address can also be configured via Web Image Monitor. For details about configuring the IP
address, see page 123 "Using Web Image Monitor".
Setting the machine to receive an IPv6 address automatically
• A DHCP server is required on the network for the machine to receive an IPv6 address
automatically.
• Make sure [DHCPv6] is set to [Enable] in [IPv6] in Web Image Monitor. For information about how
to launch Web Image Monitor, see page 123 "Using Web Image Monitor".
1. Press the [
2. Press the [ ] or [ ] key to select [Network Settings], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Machine IPv6 Address], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Use IPv6], and then press the [OK] key.
5. Press the [ ] or [ ] key to select [On], and then press the [OK] key.
After a setting is changed, the machine automatically reboots itself.
] key.
CTT006
Configuring Network Settings
17